What are the steps to turn on the medical Hydrogen compressor?

The actual responsibility of the Hydrogen compressor is to increase the pressure and increase the suction pressure state to the exhaust pressure state. Compression ratio is a technical expression of pressure difference, which means the absolute pressure on the high pressure side divided by the absolute pressure on the low pressure side.

• What are the steps to turn on the medical Hydrogen compressor?

• What should we pay attention to when the Hydrogen compressor is turned on?

• What is the working principle of the Hydrogen compressor do you know?

What are the steps to turn on the medical Hydrogen compressor?

①Check whether the inlet valve, outlet valve and vent valve of the compressor are closed.

②Open the pressure gauge valve of each line.

③Open each vent valve and bottom drain valve of the middle body and use the oil collector.

④Slightly open the nitrogen valve at the inlet, slowly feed nitrogen into the compressor to reach the airtight pressure, and then close it.

⑤ Check the compressor, ancillary equipment and pipelines for leaks.

⑥Open the venting valve of the outlet pipeline, let the gas in the machine out, and then close it.

⑦ After the airtightness is qualified, replace it again according to the airtight nitrogen filling process.

⑧ During nitrogen replacement, open each condensate drain valve to drain the condensate and then close it.

What should we pay attention to when the Hydrogen compressor is turned on?

After the electrolysis is started, the hydrogen purity is qualified and the Hydrogen compressor runs for a period of time, pay attention to observe whether the Hydrogen compressor runs smoothly and normally, and determine the status of each valve (the inlet valve is closed, the outlet valve is turned on, and the machine is turned on). Inform the Hydrogen compressor to start merging into the system, slowly open the inlet valve to ensure the stability of the system pressure, avoid large pressure fluctuations as much as possible, and maintain a relatively stable positive pressure. After that, slowly open and close the return valve until the electrolysis informs that the load has finished rising.

What is the working principle of the Hydrogen compressor do you know?

The Hydrogen compressor professionally provides a timely 4-20mA DC signal according to the process parameters to control the output frequency of the Hydrogen compressor, and then controls the speed of the motor and the delivery volume of the compressed gas of the hydrogen pump. The Hydrogen compressor is an important equipment in the drying position. When the rectifier is running, it must ensure its reliable operation, which is the focus of the electrical maintenance work. Understand the working principle of the Hydrogen compressor, and if you encounter problems in the maintenance work, you can avoid misjudgment, solve the problem quickly, and minimize the unplanned shutdown of the equipment.

For more information about Hydrogen compressor, please contact Anqing Bailian Oil Free Compressor Co.,LTD, which has committed to providing the increasing of Hydrogen compressor, and making them more effective, reliable, and consistent.